Difference between monofilament and fluorocarbon fishing line

Pros and Cons of Fluorocarbon Fishing Line. It can stretch but only under a lot of pressure.

Weakens line over time.

Difference between monofilament and fluorocarbon fishing line. The line stretch or Elasticity of each of these lines is probably one of the biggest differences between Fluorocarbon and Monofilament fishing line. Monofilament fishing line can stretch up to a third of its overall length before breaking. So if you have 90 feet of line.

Fluorocarbon Fishing Line. Denser than water so it sinks. Doesnt absorb water.

Doesnt stretch more sensitive. Virtually invisible in water. Weak knots unless you wet line first.

Water can penetrate the line. Weakens line over time. Monofilament Fishing Line Explained Monofilament isnt quite as dense as fluorocarbon.

Therefore it tends to float or at least sink at a slower rate. This is great for surface applications not so great if you are trying to fish hard on the bottom quickly. Unlike fluorocarbon mono doesnt have a.

Therefore you must pick the appropriate fishing line that knots well. Monofilament fishing lines have a higher ability to handle knots which makes them a top choice when tying prominent game leaders with extensive diameter lines. Fluorocarbon is quite stiff so knots dont sit comfortably.

Watch as I test fluorocarbon vs monofilament fishing lines in a side by side test. And dont forget to use it as the backing line for the next two types of lines. What Is Fluorocarbon Fishing Line.

Fluorocarbon is a denser non-toxic single-strand alternative to monofilament produced from a non-reactive specialty plastic used in many applications including tubing sheeting films wire insulation and of course fishing line. Pros and Cons of Fluorocarbon Fishing Line. Fluorocarbons main perk is that its practically invisible underwater.

It isnt much stronger than mono or copoly but its super abrasion resistant and lasts much longer than other lines. It can stretch but only under a lot of pressure. This means high shock strength without any loss of precision.

The fishing line comparison table below compares the three types of reel line in common use today. Thats nylon monofilament lines fluorocarbon fishing lines and braid fishing lines. And by braid lines I mean the Spectra and Dyneema HDPE super-braids - not the outdated Dacron polyester braid which is now rarely used for anything other than backing line.

Fluorocarbons most beneficial characteristic is that it has a refractive index that is much closer to that of water compared to other types of monofilament meaning that fluorocarbon is less visible to fish compared to other types of line. Monofilament fishing line is suitable for fishing in top water layers. Fluorocarbon fishing lines are suitable for fishing in deep water.

This difference between monofilament and fluorocarbon arises due to the difference between their densities. The density of monofilament is less than that of fluorocarbon line. Monofilament VS Fluorocarbon - Infographic.

Your fishing line is the only connection between you and the fish. For every successful fish story you might hear at the boat ramp there are probably many more tales about anglers left in disbelief as the fish of their dreams breaks their line – never to be seen again. So you can see that in terms of fluorocarbon vs monofilament fluorocarbon is only 07 away from the refraction index of saltwater and 09 away from freshwater.

On the other hand monofilament is 20 and 22 away respectively. If youre a big believer in fish being line shy than fluorocarbon is a must-have for you. Both fishing lines have different densities.

Monofilament - 115 gcm3. Fluorocarbon - 178 gcm3. Freshwater - 1 gcm3.

Saltwater - 102 - 103 gcm3. Fluorocarbon is denser than monofilament making it more resistant to abrasion. Monofilament is nearly the same density as water making it neutral-buoyant.

Fluorocarbon sinks more aggressively than mono and braid making it great for fishing deep-diving baits. It can also be great for fishing dead bait on the bottom in waterways with extensive boat traffic. The line itself will sink much lower than the wash caused by passing boats which will keep your bait in place.

Fluorocarbon allows a greater amount of natural light to pass through it whereas monofilament tends to refract light alerting fish of its presence. This property also makes fluoro the optimal line for fishing all sorts of crankbaits. Fluorocarbon is arguably the most versatile fishing line with a level of strength and ability to stretch that fall in-between mono and braid.

This makes it ideal for getting the most action out of lures like crankbaits jerkbaits swimbaits and jigs. Due to the increased strength of copolymer line when compared to fluorocarbon and monofilament fishing line it allows it to be comparatively thin. If you have a monofilament line you can have a copolymer line that is about half or three quarters the thickness of it but still have the same amount of strength or even more to be exact.

The line diameter tables below offer a comparison of more than 115 popular monofilament copolymer fluorocarbon fishing lines and braided superlines in tests from 6-pounds to 600-pounds If you like what you see download a copy. 6 0009 022 Berkley Vanish fluorocarbon monofilament line Fluorocarbon. The monofilament lines are easier to cast and do not tangle.

The fluorocarbon lines on the other hand need a certain degree of proficiency for accurate and tangle-free casting. If you are new to fishing it is recommended to go for monofilament lines. You can move to other kinds of lines.

In the short term fluorocarbon is much harder than the monofilament and this leads to higher abrasion resistance which is very helpful in situations where fishing is done around huge structures. Again fluorocarbon is water-resistant and hence cannot absorb water all through.